|
Features
and Specifications
MDI full featured
hybrid DC/DC Converters use a flyback topology operating at approximately
200 kHz or 300kHz. The flyback topology is especially well suited
for a wide input voltage range and for multiple output voltages.
The converters operate over an input voltage range from 5:1 (for
the low voltage series) to a range of 1.67:1 (for the 270 V series).
The range for the standard 28 VDC parts encompasses the limits of
MIL-STD-704A. The "V" series parts of the 28 VDC range can survive
the 100 VDC surges of MIL-STD-1275. Standard input to case isolation
is 500 VDC for all ranges. Standard output to case isolation is
100 VDC. Standard input to output isolation is 500 VDC. All full
featured units combine not only input MIL-STD-461 EMI filters, but
also output common mode filters for spike suppression.
The hybrids have
circuit features such as current limiting on each output, a programmable
power on soft start, open loop OVP protection, an input inhibit, built-in
test status pin and a synchronization input. All input functions except
output adjust and remote sense are referenced to the input return.
|